Neon R/T L4-2.0L VIN F HO (2001)
2. Install exhaust manifold bolts and tighten in sequence shown to 23 Nm (200 inch lbs.).
3. ULEV equipped-position upper heat shield on exhaust manifold. Install bolts and tighten to 23 Nm (200 inch lbs.).
4. Position lower and upper heat shield on exhaust manifold. Install heat shield bolts and tighten to 11 Nm (95 inch lbs.).
5. Connect oxygen sensor electrical connector and harness clip.
6. Install cylinder head cover (ULEV equipped).
7. Install speed control vacuum reservoir, if equipped.
8. Connect make-up air hose on cylinder head cover port.
9. Raise vehicle.
10. Install new flex joint to manifold flange gasket.
11. Attach exhaust system to manifold flange and tighten fasteners to 28 Nm (250 inch lbs.).
12. Install exhaust manifold support bracket and tighten fasteners (NLEV).
13. Install support bracket to cylinder block and exhaust manifold, if ULEV equipped. Snug all bolts first then tighten to 54 Nm (40 ft. lbs.).
14. Install bolt attaching wire harness heat shield to support bracket (NLEV), or exhaust manifold (ULEV).
15. Lower vehicle.
16. Connect negative cable to battery.
