Neon R/T L4-2.0L VIN F HO (2001)
High Pressure Sensor / Switch: Service and Repair
REMOVAL
WARNING: THE REFRIGERANT MUST BE REMOVED FROM THE SYSTEM BEFORE REMOVING THE HIGH PRESSURE CUT
OUT SWITCH.
1. Recover refrigerant from A/C system.
2. Disconnect wiring connector at the switch.
3. Remove internal snap ring.
4. Pull switch out of compressor.
INSTALLATION
WARNING: THE REFRIGERANT MUST BE REMOVED FROM THE SYSTEM BEFORE REMOVING THE HIGH PRESSURE CUT
OUT SWITCH.
1. Clean any foreign matter from the switch mounting bore
2. Install the high pressure cutout switch with a new O-ring into the compressor.
3. Install the internal snap ring
4. Connect the wire harness to the switch.
5. Evacuate the refrigerant system.
6. Recharge the A/C system.
