Neon R/T L4-2.0L VIN F HO (2001)
Fuel Gauge Sender: Description and Operation
FUEL LEVEL SENDING UNIT / SENSOR
The fuel gauge sending unit (fuel level sensor) is attached to the side of the fuel pump module. The sending unit consists of a float, an arm, and a
variable resistor (track). The resistor track is used to send electrical signals to the instrument cluster for fuel gauge operation and are then
transmitted to the engine controller for OBDII emission requirements.
For fuel gauge operation: As fuel level increases, the float and arm move up. This increases the sending unit resistance, causing the fuel gauge to
read full. As fuel level decreases, the float and arm move down. This decreases the sending unit resistance causing the fuel gauge to read empty.
After this fuel level signal is sent to the instrument cluster, the instrument cluster will transmit the data across the J1850 bus circuits to the PCM.
For OBD II emission requirements: The voltage signal is sent to the instrument cluster to indicate fuel level. The cluster transmits the fuel level
to the PCM where it is used to prevent a false setting of misfire and fuel system monitor trouble codes. This occurs if the fuel level in the tank is
less than approximately 15 percent of its rated capacity.
