Neon R/T L4-2.0L VIN F HO (2001)
Alignment: Service and Repair
Pre-Alignment Inspection
STANDARD PROCEDURE - WHEEL ALIGNMENT
PRE-WHEEL ALIGNMENT VEHICLE INSPECTION
CAUTION: If during the inspection the front suspension crossmember shows any sign of impact damage, the steering column lower coupling must
be inspected.
Before any attempt is made to change or correct the wheel alignment, the following inspection and necessary corrections must be made to the vehicle
to ensure proper alignment.
1. Be sure the fuel tank is full of fuel. If the fuel tank is not full, the reduction in weight will affect the curb height of the vehicle and the alignment
specifications.
2. The passenger and luggage compartments of the vehicle should be free of any load that is not factory equipment.
3. Check the tees on the vehicle. The tires are to be inflated to the recommended air pressure. All tires must be the same size and in good condition
with approximately the same tread wear.
4. Check the front tire and wheel assemblies for excessive radial runout.
5. Inspect all suspension component fasteners for looseness and torque.
6. Inspect the lower front ball joints and all steering linkage for looseness and any sign of wear or damage.
7. Inspect the rubber bushings on all the suspension components for signs of wear or deterioration. If any bushings show signs of wear or
deterioration, they should be replaced prior to aligning the vehicle.
