Neon R/T L4-2.0L VIN F HO (2001)
10. Place the steering knuckle back in the arbor press supported by press blocks as shown. The press blocks must not obstruct the bore in the steering
knuckle so the wheel bearing can be pressed out of the steering knuckle. Place Bearing Driver, Special Tool MB-990799 on the outer race of
wheel bearing. Press the wheel bearing out of the
11. Install Bearing Splitter, Special Tool 1130, on the hub. The bearing splitter is to be installed on the hub so it is between the flange of the hub and
the outer bearing race on the hub. Place the hub, bearing race and bearing splitter in an arbor press as shown. Place Driver, Special Tool 6644-2 on
end of hub. Press the hub out of the outer bearing race.
ASSEMBLY (WHEEL BEARING AND HUB)
NOTE: The removal and installation of the wheel bearing and hub from the steering knuckle is only to be done with the steering knuckle removed from
the vehicle.
1. Wipe the empty bore of the steering knuckle clean of any grease or dirt with a clean, dry shop towel.
