Neon R/T L4-2.0L VIN F HO (2001)
3. Remove two bolts attaching Driver Airbag from the sides of steering wheel.
4. Lift airbag and disconnect airbag squib wire connector and horn wire.
5. Remove Driver Airbag from vehicle.
NOTE: When replacing a deployed driver airbag, the clockspring must also be replaced. Refer to Electrical, Restraints, Clockspring, Removal.
INSTALLATION
1. Connect the squib wire to the airbag. Make airbag connection by pressing straight in on the connector. The connector should be fully seated. Feel
for positive snap to assure positive connection.
2. Connect the horn wire.
3. Install two bolts and tighten to 10 to 11 Nm (90 to 100 in. lbs.) torque.
4. Install covers to the steering wheel armature or connect the wire connectors to the speed control switches and install switches. Tighten fastener to 2
Nm (20 in. lbs.) torque.
WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS
AND TESTING - AIRBAG SYSTEM FIRST.
