Neon R/T L4-2.0L VIN F HO (2001)
Fig.21 Seat Airbag Electrical Connector
7. Disconnect the seat airbag electrical connector. Slide yellow locking tab down to unlock. Then with two fingers, push two side retaining tabs in
and pull connector straight from module.
8. Remove the seat airbag retaining nuts.
9. Grasp the upper airbag side of the seat back trim cover and pull trim cover and cushion over top of seat back frame. This will allow room to
remove seat airbag without damaging trim cover or cushion.
10. Working between seat back trim cover/cushion and frame carefully unhook seat airbag studs from nylon sleeve and slide seat airbag out of sleeve.
Be careful not to tear nylon sleeve as this will affect function of airbag system.
CAUTION: Be certain not to tear the side impact airbag module nylon sleeve during removal.
INSTALLATION
NOTE: The seat airbag connector must face down (toward seat cushion) after installation.
1. Carefully slide the seat airbag in nylon sleeve until mounting studs line up with holes provided in nylon sleeve. Be careful not to tear nylon sleeve
as this will affect function of airbag system.
CAUTION: The seat airbag must be inside the nylon sleeve before installing retaining nuts. Failure to do so will adversely affect the function of
the side impact airbag system.
