Neon R/T L4-2.0L VIN F HO (2001)
Fig.18 Terminal Removal Using Special Tool
4. Position the connector locking finger away from the terminal using the proper pick from special tool kit 6680. Pull on the wire to remove the
terminal from the connector (Fig. 17) (Fig. 18).
5. Cut the wire 6 inches from the back of the connector.
6. Remove 1 inch of insulation from the wire on the harness side.
INSTALLATION
1. Select a wire from the terminal repair assembly that best matches the color wire being repaired.
2. Cut the repair wire to the proper length and remove one-half (1/2) inch of insulation.
3. Splice the repair wire to the wire harness
a. Place a piece of heat shrink tubing over one side of the wire. Make sure the tubing will be long enough to cover and seal the entire repair area.
b. Spread the strands of the wire apart on each part of the exposed wires.
c. Push the two ends of wire together until the strands of wire are close to the insulation.
d. Twist the wires together.
e. Solder the connection together using rosin core type solder only. Do not use acid core solder.
f.
Center the heat shrink tubing over the joint and heat using a heat gun. Heat the joint until the tubing is tightly sealed and sealant comes out of
both ends of the tubing.
4. Insert the repaired wire into the connector.
5. Install the connector locking wedge, if required, and reconnect the connector to its mating half/component.
6. Re-tape the wire harness starting at 1-1/2 inches behind the connector and 2 inches past the repair.
7. Connect battery and test all affected systems.
Terminal/Connector Repair-Augat Connectors
REMOVAL
1. Disconnect battery.
2. Disconnect the connector from its mating half/component.
