Neon R/T L4-2.0L VIN F HO (2001)
5. Remove the upper mount from the strut shaft.
6. Remove the upper spring seat and bearing, along with the upper spring isolator as an assembly From the top of the coil spring by pulling them
straight up. The upper spring isolator can be separated from the spring seat and bearing once removed from vehicle.
7. Remove the dust shield, then the jounce bumper from the strut shaft by pulling each straight up.
8. Remove the clamp from the bottom of the coil spring and remove the strut out through the bottom of the coil spring.
9. Remove the lower spring isolator from the lower spring seat on the strut.
NOTE: If the coil spring needs to be serviced, proceed with the next step, otherwise, proceed with step 11.
10. Release the tension from the coil spring by backing off the compressor drive completely. Push back the compressor hooks and remove the coil
spring.
11. Inspect the strut assembly components for the following and replace as necessary:
-
Inspect the strut for any condition of shaft binding over the full stroke of the shaft.
-
Inspect the jounce bumper for cracks and signs of deterioration (non-ACR vehicles only).
-
Check the upper mount for cracks and distortion and its retaining studs for any sign of damage.
-
Check the upper spring seat and bearing for cracks and distortion.
-
Check for binding of the upper spring seat and bearing pivot bearing.
-
Inspect the dust shield for rips and deterioration.
-
Inspect the upper and lower spring isolators for material deterioration and distortion.
-
Inspect the coil spring for any sign of damage to the coating.
Assembly
ASSEMBLY - STRUT ASSEMBLY (FRONT)
For the disassembly and assembly of the strut assembly, use strut spring compressor, Pentastar Service Equipment (PSE) tool W-7200, or the equivalent,
to compress the coil spring. Follow the manufacturer's instructions closely.
NOTE: If the coil spring has been removed from the spring compressor, proceed with the next step, otherwise, proceed with step 3.
