Neon R/T L4-2.0L VIN F HO (2001)
4. Place the previously removed wheel mounting stud back into the hub flange. Place the hub in the arbor press supported by Special Tool C-4698-1.
Press wheel mounting stud into hub flange until it is fully seated against the back side on the hub flange. Remove the hub from the press.
5. Place the steering knuckle with the wheel bearing installed back in the arbor press with Receiver, Special Tool MB-990799 supporting the inner
race of the wheel bearing as shown. Place the hub in wheel bearing making sure it is square with the bearing inner race. Press the hub into the
wheel bearing until it is fully bottomed in the wheel bearing. Remove the knuckle from the press.
6. Install the steering knuckle assembly on the vehicle.
