Neon R/T L4-2.0L VIN F HO (2001)
6. Remove two pedal assembly bracket to instrument panel nuts (Fig. 10).
7. Remove four brake booster/pedal bracket-to-cowl panel nuts (Fig. 10).
8. From under the hood, pull brake master cylinder/booster far enough forward to obtain pedal to bracket stud clearance.
9. Remove the pedal bracket assembly (Fig. 10).
10. Remove pedal pivot shaft and remove brake and clutch pedals.
11. Remove the interlock/upstop switch assembly (Fig. 11) from the brake/clutch pedal bracket assembly by depressing the four plastic wing tabs on
each switch.
INSTALLATION
NOTE: Proper switch harness routing is critical to switch durability. Note the harness routing and location of fasteners intended to keep wires from
contacting pedals.
