Neon R/T L4-2.0L VIN F HO (2001)
6. Slide halfshaft back into front hub. Install steering knuckle onto the ball joint stud (Fig. 11).
NOTE: At this point, the outer joint will not seat completely into the front hub. The outer joint will be pulled into hub and seated when the hub
nut is installed and torqued.
7. Install a PMW steering knuckle to ball joint stud bolt and nut (Fig. 11). Tighten the nut and bolt to 95 Nm (70 ft. lbs.).
8. Clean all foreign matter from threads of halfshaft outer stub axle. Install hub nut onto the threads of the stub axle and tighten nut to 244 Nm (180
ft. lbs.) (Fig. 12).
