Neon R/T L4-2.0L VIN F HO (2001)
2. Install spider assembly onto interconnecting shaft with chamfer on spider assembly toward interconnecting shaft (Fig. 19). Spider assembly must
be installed on interconnecting shaft far enough to fully install spider retaining snap ring. If spider assembly will not fully install on
interconnecting shaft by hand, it can be installed by tapping the spider body with a brass drift (Fig. 20). Do not hit the outer tripod bearings in an
attempt to install spider assembly on interconnecting shaft.
3. Install the spider assembly to interconnecting shaft retaining snap ring into groove on end of interconnecting shaft (Fig. 21). Be sure the snap ring
is fully seated into groove on interconnecting shaft.
4. Distribute 1/2 the amount of grease provided in the seal boot service package (DO NOT USE ANY OTHER TYPE OF GREASE) into tripod
housing. Put the remaining amount into the sealing boot.
