Neon R/T L4-2.0L VIN F HO (2001)
Power Window Switch: Service and Repair
Battery Negative Cable Remove/Install
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Using a trim stick (special tool #C-4755) or equivalent, gently pry up on window switch bezel and remove from door trim panel.
3. Disconnect wire connector from switch.
4. Remove two switch retaining screws.
INSTALLATION
1. Install the switch retaining screws.
2. Reconnect the wire connector to the switch.
3. Insert switch into the door trim panel.
4. Reconnect the battery negative cable.
