Neon R/T L4-2.0L VIN F HO (2001)
INSTALLATION
1. Clean butyl material from door flange area.
2. Place door run weatherstrip in position on window frame channel.
3. Push door run weatherstrip into window frame channel.
4. Push weatherstrip into lower front channel above door latch.
5. Install weatherstrip fasteners.
6. Install door glass.
7. Tighten side view mirror.
8. Install pull cup support bracket, water shield, door trim panel and flag trim.
Outer Belt Weatherstrip
OUTER BELT WEATHERSTRIP
REMOVAL
1. Open door glass.
2. Pull upward at rear end of outer belt weatherstrip.
Fig. 3
3. Remove outer belt weatherstrip from vehicle (Fig. 3).
INSTALLATION
1. Starting at leading edge of door, press weatherstrip onto door.
2. Operate window and check for interference.
Door Upper Secondary Weatherstrip
DOOR UPPER SECONDARY WEATHERSTRIP
REMOVAL
1. Using a fork-type prying tool, disengage push in fasteners attaching door upper secondary weatherstrip to door opening.
2. Remove weatherstrip from door.
INSTALLATION
1. Position weatherstrip to opening door.
2. Press door upper secondary weatherstrip fasteners into position.
Front/Rear Door Inner Belt Weatherstrip