Nitro 2WD V6-3.7L (2011)
6. Cut the drain tube flush with the plenum closure (Fig 2) and (Fig 3).
CAUTION:
Be sure not to scratch the metal housing on the cowl panel. If scratching occurs treat area with 3M(TM) Single Step Primer p/n 08681.
7. Position the air inlet screen (1) into the cowl panel (3) and fully engage the screen onto the two retaining studs (4) (Fig 1).
8. Install the air inlet screen onto the cowl panel and install the two retaining nuts (4). Tighten the nuts to 2.3 N.m (20 in.lbs.) (Fig. 1).
9. Install the cowl panel. Refer to the detailed procedures available in DealerCONNECT/TechCONNECT group 23 - Body > Exterior > Cover, Cowl
Panel Install.
POLICY:
Reimbursable within the provisions of the warranty.
