Nitro 2WD V6-4.0L (2007)
Remote Switch: Service and Repair
Installation
INSTALLATION
WARNING: Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag, or instrument
panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the airbag system
capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the
proper precautions could result in accidental airbag deployment and possible personal injury.
1. Install remote radio switch to the steering wheel.
2. Connect the wire harness to the remote radio switch.
3. Install the speed control switches.
4. Install the driver side airbag.
5. Connect the battery negative cable.