Nitro 2WD V6-4.0L (2007)
Hood Sensor/Switch (For Alarm): Service and Repair
Installation
INSTALLATION
1. Position the hood ajar switch (2) near the mounting hole in the front end module carrier to the right of the hood latch.
2. Pull the wire harness connector (3) through the switch mounting hole and reconnect it to the switch connector receptacle.
3. From the top of the mounting hole, press the switch downward into the mounting hole until the integral switch latch tabs lock it into place.
4. Reinstall the grille panel (1) onto the front of the vehicle.
5. Reconnect the battery negative cable.
6. Close and latch the hood.
