Nitro 2WD V6-4.0L (2007)
Front Door Panel: Service and Repair
Installation
INSTALLATION
CAUTION: Pay close attention to the plastic hook attachment points on the inside of the door trim panel. Make sure that every hook is
correctly positioned to the door when installing the trim panel. Damage to the trim panel will occur if the hooks in the door panel are not
properly positioned to the door during installation.
1. Connect the electrical connectors and install the power window switch.
2. Carefully install the door trim panel (4) to the door (1) by lifting upward and over the door lock into the trim panel then attach the trim panel to the
carrier plate attachment points.
3. Install the screws (2) and the cap screw covers (3) to the front door trim (4).
4. Install the fastener (5) at the handle area of the front door trim (4) and tighten screw to 5.5 Nm (50 in. lbs.).
5. Install the door handle trim bezel (6).