Nitro 2WD V6-4.0L (2007)
2.
Lay the bezel face down on a soft surface. Apply two (2) pieces of flock tape, p/n 05019055AA to the back side of the bezel. Tape should not roll
up the angled taper or hang off the outside edge (Fig. 1).
3.
**Remove door trim panel**.
4.
Apply cloth electrical tape/friction tape to the door wire harness as shown, removing the tie straps as you apply the tape as shown (Fig 2).
NOTE:
Use cloth tape only, vinyl tape may cause a squeak.
