Nitro 2WD V6-4.0L (2007)
Rear Door Panel: Service and Repair
Removal
REMOVAL
1. Remove the door handle trim bezel (6).
2. Remove the fastener (5) from the handle area of the front door trim (4).
3. Use a very thin pry tool to remove the cap screw covers (3) from the door trim (4).
4. Remove the screws (2) from the front door trim (4).
5. Remove the power window switch and disconnect the electrical connector.
6. Disengage the trim panel from the four way locator at the handle area of the trim panel, then carefully remove the door trim panel (4) from the
door (1) by lifting upward until removed from the door lock and the mounting attachments on the carrier plate.
