Nitro 2WD V6-4.0L (2007)
Rear Door Panel: Service and Repair
Installation
INSTALLATION
1. Carefully install the door trim panel (4) to the door (1) by lifting upward and over the door lock into the trim panel then attach the trim panel to the
carrier plate attachment points.
2. Connect the electrical connector and install the power window switch.
3. Install the screws (2) to the front door trim (4).
4. Install the cap screw covers (3) to the front door trim (4).
5. Install the fastener (5) at the handle area of the front door trim (4) and tighten screw to 5.5 Nm (50 in. lbs.).
6. Install the door handle trim bezel (6).