Nitro 2WD V6-4.0L (2007)
Trim Panel: Service and Repair
Cowl Trim
Removal
REMOVAL
1. Using a trim stick C-4755 or equivalent, remove the cowl trim cover (1) by pulling it away from the A-pillar and releasing the clip (2), continue
lifting up the cowl trim panel (1) to release the clips (3) from the body.
Installation
INSTALLATION
1. Align and install the cowl trim cover (1) by sliding the rear tabs of the cowl trim cover under the B-pillar trim.
CAUTION: When installing the cowl trim cover make sure not to damage the body plugs around the sill area. If damage occurs to the body
plugs replace with new plugs. Failure to replace a damaged body plug will result in a water leak to the floor area of the vehicle.
2. Using hand pressure install the clips (3) into the body and the A-pillar (2).
