Nitro 2WD V6-4.0L (2007)
1. Using a small pry tool or equivalent, lift the A-pillar trim molding (3) from the A-pillar slots (2) releasing the clips on the molding.
2. Remove the top clip from the trim molding.
Installation
INSTALLATION
1. Align the A-pillar trim tab on the molding (3) to the top cover slot of the instrument panel (1).
2. Install the top clip on the trim molding.
3. Align the two clips on the molding to the slots (2) on the A-pillar. Snap the A-pillar trim molding (3) into place using hand pressure.
Removal
REMOVAL
