Nitro 2WD V6-4.0L (2007)
Sunroof / Moonroof Panel: Adjustments
SUNROOF GLASS PANEL ADJUSTMENT
1. Move the sunshade rearward to the open position.
2. Move the sunroof glass panel to the fully closed position.
3. Adjust the glass one corner at a time.
a. Loosen four glass screws (1).
b. Lift glass assembly and align the top of the glass panel to the top of the roof panel.
c. Tighten screw to 3.5 Nm (31 in. lbs.).
d. Repeat steps a. and b. for each corner of the glass panel.
e. When properly adjusted, the front of the glass panel is flush to 2 mm (0.78 in.) lower than the roof surface and the rear edge of the glass panel
is flush to 2 mm (0.78 in.) lower than the roof surface.
NOTE: When properly adjusted, the front of the glass panel (3) is flush to 2 mm (0.78 in.) lower than the roof surface (2).
