Nitro 2WD V6-4.0L (2007)
Seat Heater Switch: Service and Repair
Installation
INSTALLATION
NOTE: There are different accessory switch banks available based on the option content of the vehicle. Ensure the switch pod being installed matches
the vehicle options.
1. Position the accessory switch bank (3) onto the back of the instrument panel center bezel (1).
2. Install the four screws (2) that secure the accessory switch bank to the center bezel. Tighten the screws to 2 Nm (17 in. lbs.).
3. Install the center bezel onto the instrument panel.
4. Connect the battery negative cable.
5. Verify heated seat system operation.