Nitro 2WD V6-4.0L (2007)
Wheel Speed Sensor: Service and Repair
Sensor- Wheel Speed-Rear
Removal
REMOVAL
1. Raise and support the vehicle.
2. Disengage the locking tab connector (1).
3. Disconnect the wheel speed sensor electrical connector (1).
4. Remove the wheel speed sensor mounting bolt (2) from the rear support plate.
5. Remove the wheel speed sensor from the support plate.
Installation
INSTALLATION
1. Insert the wheel speed sensor through the support plate.
2. Tighten the wheel speed sensor bolt (2) to 9 Nm (80 in. lbs.).
3. Secure the wheel speed sensor wire to the routing clips. Verify that the sensor wire is secure and clear of the rotating components.
4. Reconnect the wheel speed sensor electrical connector (1).
NOTE: Make sure the connector locking tab is fully engaged and locked in position.
5. Lower the vehicle.