Nitro 2WD V6-4.0L (2007)
6. If replacing the reservoir (1) remove the fluid level sensor (2) by squeezing the tabs together while pulling on the sensor (2).
7. Remove old grommets (2) from cylinder body (1).
Installation
INSTALLATION
CAUTION: Do not use any type of tool to install the grommets (2). Tools may cut, or tear the grommets creating a leak problem after
installation. Install the grommets using finger pressure only and insure that the grommets are properly seated.
1. Lubricate new grommets (2) with clean brake fluid and Install new grommets (2) in cylinder body (1). Use finger pressure to install and seat
grommets.
