Nitro 2WD V6-4.0L (2007)
b.
Install a screwdriver into the lever tab hole and drum cut-out (Figure 3).
c.
Release the core cable.
d.
The park brake system is now locked out to perform this procedure.
9.
Disconnect the park brake cables at the cable equalizer (Figure 4)
10.
Disconnect the brake lamp switch electrical connector located on the side of the park brake lever assembly
11.
Remove the four (4) park brake lever assembly attaching nuts (Figure 4).
12.
Remove the park brake lever assembly from the vehicle.
13.
Carefully remove the screwdriver from the old park brake lever and discard the old lever.
CAUTION:
Keep hands free of moving parts. The drum will rotate when the screwdriver is removed.
14.
Place the new park brake lever into position.
15.
Install the four (4) park brake lever mounting nuts and tighten to 140 in. lbs. (16 N.m) (Figure 4).
