Nitro 2WD V6-4.0L (2007)
Measure the resistance between ground and the (N1) Fused Fuel Pump Output circuit at the Fuel Pump Module harness connector.
Is the resistance below 100 ohms?
Yes
-
Repair the short to ground in the (N1) Fused Fuel Pump Output circuit.
-
Perform the POWERTRAIN VERIFICATION TEST. See: Powertrain Management/Computers and Control Systems/Testing and
Inspection/Diagnostic Trouble Code Tests and Associated Procedures/Verification Tests/Powertrain Verification Test
No
-
Go To 10
10. FUEL PUMP MODULE/TIPM
Connect the C3 PCM harness connector.
Connect the C1 and C5 TIPM harness connectors.
Turn the ignition on.