Nitro 2WD V6-4.0L (2007)
4. Align the pulley and bearing assembly (1) squarely onto the front of the A/C compressor (2).
NOTE: A distinct change of sound during the clutch pulley tapping process indicates that the pulley and bearing assembly has bottomed out
against the compressor housing.
5. Using clutch pulley installer (Special Tool 9355 in Kit 9349) (3) and a hammer (4), install the pulley and bearing assembly onto the front of the
A/C compressor. Tap the installer with a hammer until the pulley and bearing assembly has bottomed against the compressor housing.
CAUTION: If the snap ring is not fully seated in the groove it will vibrate out, resulting in clutch failure and severe damage to the A/C
compressor.
NOTE: Install the snap ring with the beveled side of the snap ring facing outward.
6. Using snap ring pliers (Special Tool 9764 or equivalent) (1), install the snap ring (2) that secures the pulley and bearing assembly (3) to the front
of the A/C compressor (4). Make sure the snap ring is properly seated in the groove.
