Nitro 2WD V6-4.0L (2007)
13. Disengage the retainers that secure the air deflector vane (1) to the lower half of the HVAC housing (2) and remove the deflector vane.
14. If required, remove the foam seal (3) from around the condensate drain located at the bottom of the HVAC housing.
Air Distribution Housing
HOUSING-AIR DISTRIBUTION
WARNING: The heater core tubes are not serviced separately from the heater core. The heater core tubes should not be repositioned, loosened
or removed from the heater core. Failure to follow this warning could result in a coolant leak and possible personal injury or death.
NOTE: LHD model shown in illustrations. RHD model similar.
NOTE: If the seal on any air door is deformed or damaged, that air door must be replaced.
1. Install the floor-air door (1), blend-air door (2), panel-air door (3) and the defrost-air door (4) into the driver side of the air distribution housing (5)
as required. Align the air door pivot shafts with the holes in the housing.
