Nitro 2WD V6-4.0L (2007)
13. If equipped with the 2.8L diesel engine, install the electric positive temperature coefficient (PTC) heater unit.
14. Install the blend door cam (5), blend door lever (6), blend door gear (4), panel door gear (3), mode door cam (2), and the defrost door lever and
gear assembly (1) onto the driver side of the air distribution housing (7).
15. Install the driver side front floor duct (7) onto the driver side of the air distribution housing (4) and install the two retaining screws (8). Tighten the
screws to 1.2 Nm (10 in lbs.).
16. Position the actuator mounting bracket (5) onto the air distribution housing and install the three retaining screws (1). Tighten the screws to 1.2 Nm
(10 in lbs.).
17. Position the mode door actuator (2) and the blend door actuator (6) onto the actuator mounting bracket. If necessary, rotate the actuator slightly to
align the splines on the actuator output shaft with those on the door linkage.
18. Install the screws (3) that secure the mode and blend door actuators to the actuator mounting bracket. Tighten the screws to 1.2 Nm (10 in lbs.).
19. Install the air distribution housing onto the HVAC housing.
20. Install the HVAC housing assembly.
Air Inlet Housing
HOUSING-AIR INLET
NOTE: LHD model shown in illustrations. RHD model similar.
