Nitro 2WD V6-4.0L (2007)
License Plate Lamp: Service and Repair
Installation
INSTALLATION
CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the
lamp, the socket or the lamp wiring.
NOTE: The following procedure is for replacement of a license plate lamp bulb. The license plate lamps are integral to the liftgate handle and light bar
unit. If any part of this unit is ineffective or damaged, the entire handle and light bar unit must be replaced.
1. Align the base of the bulb (2) with the socket (1) in the outboard side of the license plate lamp housing.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Position the lens (3) over the lamp housing under the handle and light bar unit (2).
4. Engage the two tabs on the inboard side of the lens into the slots on the inboard side of the lamp housing.
5. Push the outboard side of the lens upward until the lens latch tab (1) is fully engaged in the lamp housing.
6. Reconnect the battery negative cable.
