Nitro 2WD V6-4.0L (2007)
Technical Service Bulletin # G25
Date: 070701
Recall - TIPM Reprogramming for Engine Stalling
July 2007
Dealer Service Instructions for:
Safety Recall G25
Reprogram TIPM Engine Stalling
Models
2007 (JK) Jeep(R) Wrangler
2007 (KA) Dodge Nitro
NOTE:
This recall applies only to the above vehicles built through January 22, 2007 (MDH 012200).
IMPORTANT:
Some of the involved vehicles may be in dealer new vehicle inventory. Federal law requires you to complete this recall service on these vehicles
before retail delivery. Dealers should also consider this requirement to apply to used vehicle inventory and should perform this recall on vehicles in
for service. Involved vehicles can be determined by using the VIP inquiry process.
Subject
The Totally Integrated Power Module (TIPM) on about 80,800 of the above vehicles was programmed with software that may allow the engine to stall
under certain operating conditions. This could cause a crash without warning
Repair
The Totally Integrated Power Module (TIPM) must be reprogrammed (flashed).
NOTE:
Wrangler models with a disconnecting stabilizer bar (sway bar) option (sales code SHG) require additional unique steps in the flash procedure.
Parts Information
No parts are required to perform this service procedure.
Special Tools
These existing special tools may be required to perform this repair.
