Nitro 2WD V6-4.0L (2007)
h.
Select "Close" after the download is complete, then select "Back".
i.
Highlight the listed calibration.
j.
Select "Update Controller".
k.
When the update is complete, select "OK".
7.
Verify the part number at the top of the "Flash PCM" screen has updated to the new part number.
NOTE:
Due to the PCM programming procedure, a DTC may be set in other modules within the vehicle, if so equipped. Some DTC's may cause the MIL to
illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press "Clear All Stored DTCs" if there are any DTCs shown on
the list.
NOTE:
The following step is required by law when reprogramming a PCM and/or TCM.
8.
Type the necessary information on the "Authorized Modification Label p/n 04275086AB and attach near the VECI label (Fig 1).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.