Nitro 2WD V6-4.0L (2007)
o. Using a soldering gun, apply solder to both brass crimps installed in Steps 4m and 4n (Figure 9).
CAUTION:
Use only rosin core solder.
p. Slide the heat shrink tube over the soldered brass crimp on each wire.
q. Using a heat gun, heat the shrink tube until it fits tight against the wire and glue comes out of the end of the shrink tube.
5. Install the red wire from the overlay wiring harness into the green TIPM connector using the following procedure:
a. Carefully disconnect the green TIPM connector from the TIPM by sliding the red lock tab towards the TIPM, then unlatch the gray lock bar and
pull on the connector body (Figure 10).
b.
Remove the electrical tape from the vehicle wiring harness leading up to the green TIPM connector.
