Nitro 2WD V6-4.0L (2007)
6. Replace the ECM with the appropriate Generic ECM.
7. Program the ECM as follows:
a. Using the StarSCAN(R) or equivalent at the "Home" screen, Select "ECU View"
b. Touch the screen to highlight the ECM in the list of modules.
c. Select "More Options"
d. Select "ECU Flash"
e. Select "Browse for New File". Follow the on screen instructions.
f. Highlight the appropriate calibration based on the part number recorded in Step 5.
g. Select "Download to Scantool".
h. Select "Close after the download is complete, then select "Back".
i. Highlight the listed calibration.
j. Select "Update Controller". Follow on screen instructions.
k. When the update is complete, select "OK".
l. Verify the part number at the top of the "Flash ECM" screen has updated to the new part number.
8. Is "WCM - Wireless Control Module" displayed in the "ECU Overview" screen list of modules?
a. Yes >> go to STEP 9.
b. No >> go to STEP 10.
9. Program the ECM to the Wireless Control Module (WCM).
a. Highlight the WCM.
b. Select "Misc. Function".
c. Highlight "ECM Replaced".
d. Select "Start"
e. Follow the on screen instructions. Select "Next" after each step. Select "Finish" after completing the last step.
f. When complete proceed to.
10. Program the VIN into the ECM.
a. Scroll through the list of controllers and highlight the ECM.
b. Select "Misc. Function".
c Highlight "Check ECM VIN".
d. Select "Start"
e. Follow the on screen instructions. Select "Next" after each step. When the window appears with 17 boxes, select "Show Keyboard". Place
the cursor to the right of the last box and then backspace to delete the boxes from the window. Enter the VIN. Select "Finish" after completing
the last step.
f. Unplug the scan tool from the Data Link Connector.
g. At the "Vehicle Disconnected" screen, press "OK".
h. Connect the scan tool to the Data Link Connector and verify that the VIN is visible at the top of the "Home" screen.
NOTE: Due to the ECM programming procedure, a DTC may be set in other modules (TCM, BCM, MIC, SKREEM, etc.) within the vehicle,
if so equipped. Some DTC's may cause the MIL to illuminate. From the "Home" screen select "System View". Then select "All DTCs". Press
"Clear All Stored DTCs" if there are any DTCs shown on the list.
NOTE: The following step is required by law when reprogramming a ECM and/or TCM.
