Nitro 2WD V6-4.0L (2007)
1. Position the front seat belt buckle and tensioner unit (1) to the inboard seat cushion frame.
2. Insert the seat belt tensioner and seat belt switch (driver side only) pigtail wire (3) connector under the seat through the clearance hole in the
inboard seat cushion frame.
3. Position the front seat belt buckle lower anchor to the back of the inboard seat cushion frame.
4. Install and tighten the screw (2) that secures the front seat belt buckle anchor to the seat cushion frame. Tighten the screw to 43 Nm (32 ft. lbs.).
5. Reconnect the seat belt buckle tensioner and seat belt switch (driver side only) pigtail wire connector to the seat wire harness connector located
under the seat cushion near the inboard side of the seat.
6. Reinstall the front seat into the vehicle.
7. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
Second Row Center And Right Outboard
SECOND ROW CENTER AND RIGHT OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
1. Position the center and right seat belt buckle unit (2) between the second row seat cushions (10).
2. Position the lower anchor of the seat belt buckle unit to the inboard side of the right center seat bracket (7). Be certain that the anti-rotation tab on
the anchor is engaged in the notch of the bracket.
3. Install and tighten the screw (6) that secures the buckle anchor to the right center seat bracket. Tighten the screw to 55 Nm (41 ft. lbs.).
4. Lower the front edge of the seat cushions downward and align the seat cushion legs (8) to the holes in the rear floor panel (9).
5. Install and tighten the four screws (1) that secure the legs to the floor panel. Tighten the screws to 54 Nm (40 ft. lbs.).
Second Row Center Anchor And Left Outboard
SECOND ROW CENTER ANCHOR AND LEFT OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
