Nitro 2WD V6-4.0L (2007)
Seat Belt Reminder Lamp: Description and Operation
Operation
OPERATION
The seatbelt indicator gives an indication to the vehicle operator of the status of the driver side front seat belt. This indicator is controlled by a transistor
on the instrument cluster circuit board based upon cluster programming and a hard wired input from the seatbelt switch on the driver side front seat belt
retractor through the seat belt switch sense circuits.
The seatbelt indicator also includes a programmable enhanced seatbelt reminder or BELTMINDER feature that is enabled when the vehicle is shipped
from the factory. This BELTMINDER feature can be disabled and enabled by the customer using a specific programming event sequence, or by the
dealer using a diagnostic scan tool.
The seatbelt indicator Light Emitting Diode (LED) is completely controlled by the instrument cluster logic circuit, and that logic will only allow this
indicator to operate when the instrument cluster receives a battery current input on the fused ignition switch output (run-start) circuit. Therefore, the LED
will always be OFF when the ignition switch is in any position except ON or START. The LED only illuminates when it is provided a path to ground by
the instrument cluster transistor. The instrument cluster will turn ON the seatbelt indicator for the following reasons:
-
Seatbelt Reminder Function - Each time the cluster receives a battery current input on the fused ignition switch output (run-start) circuit, the
indicator will be illuminated as a seatbelt reminder for about six seconds, or until the ignition switch is turned to the OFF position, whichever
occurs first. This reminder function will occur regardless of the status of the seatbelt switch inputs to the cluster.
-
Front Seatbelt Not Buckled - Beltminder Active - Following the seatbelt reminder function, each time the cluster detects an open circuit on the
front seat belt switch sense circuit (seatbelt switch open = seatbelt unbuckled) with the ignition switch in the START or ON positions, the indicator
will be illuminated. In addition, if the front seat belt remains unbuckled about 4 seconds after the conclusion of the seatbelt reminder function, the
seatbelt indicator will begin to cycle between flashing ON and OFF for 3 seconds, then lighting solid for 2 seconds. The seatbelt indicator will
continue to cycle between flashing and solid illumination for 13 complete cycles, until the seat belt switch sense input to the cluster is a closed
circuit to ground (seatbelt switch closed = seatbelt buckled), or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Front Seatbelt Not Buckled - Beltminder Inactive - Following the seatbelt reminder function, each time the cluster detects an open circuit on
the seat belt switch sense circuit (seatbelt switch open = seatbelt unbuckled) with the ignition switch in the START or ON positions, the indicator
will be illuminated. The seatbelt indicator remains illuminated until the seat belt indicator input to the cluster is a closed circuit to ground (seatbelt
switch closed = seatbelt buckled), or until the ignition switch is turned to the OFF position, whichever occurs first.
-
Actuator Test - Each time the cluster is put through the actuator test, the seatbelt indicator will be turned ON, then OFF again during the bulb
check portion of the test to confirm the functionality of the LED and the cluster control circuitry.
The seatbelt switch is connected in series between ground and the seat belt switch sense circuit input to the instrument cluster. The seatbelt switch input
to the instrument cluster circuitry may be diagnosed using conventional diagnostic tools and procedures. Refer to the appropriate wiring information.
