Nitro 2WD V6-4.0L (2007)
1. Position the second row center seat belt and retractor unit (1) onto the 60 percent seat back panel (2). Be certain to engage the tab on the retractor
frame into the keyed hole in the back panel.
2. Install and tighten the screw (4) that secures the retractor to the seat back panel. Tighten the screw to 55 Nm (41 ft. lbs.).
3. Reinstall the foam, trim cover and bezel (3) onto the seat back panel. Be certain the seat belt webbing between the retractor and the bezel is not
twisted.
4. Reinstall the second row seat into the vehicle as a unit.
5. Reinstall the left second row seat belt buckle and center seat belt lower anchor unit (5) onto the rear floor panel.
Second Row Outboard
SECOND ROW OUTBOARD
WARNING: To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts,
buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut,
frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or
retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the
anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or
ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the DaimlerChrysler
Mopar(R) Parts Catalog.
NOTE: All seat belt retractors except the driver side front and the second row center retractor include a switchable automatic locking mechanism.
1. Position the second row outboard seat belt (4) and retractor (6) to the lower inner C-pillar (1) as a unit.
2. Install and tighten the screw (5) that secures the retractor bracket to the lower C-pillar. Tighten the screw to 44.5 Nm (33 ft. lbs.).
3. Reinstall the quarter trim panel onto the lower C-pillar.
4. Position the seat belt turning loop to the upper C-pillar. Be certain the seat belt webbing between the retractor and the turning loop is not twisted.
5. Install and tighten the screw (3) that secures the seat belt turning loop to the upper C-pillar. Tighten the screw to 44.5 Nm (33 ft. lbs.).
6. Reinstall the trim (2) onto the upper C-pillar.
