Nitro 2WD V6-4.0L (2007)
1. Reconnect the body wire harness connector (3) to the side impact sensor (2) connector receptacle.
2. Position the impact sensor onto the weld stud on the inner C-pillar (4). Be certain that the anti-rotation pin on the back of the sensor is engaged in
the clearance hole of the C-pillar.
3. Install and tighten the nut (1) that secures the sensor to the weld stud on the inner C-pillar. Tighten the nut to 7 Nm (62 in. lbs.).
4. Reinstall the trim onto the inside of the lower C-pillar.
5. Do not reconnect the battery negative cable at this time. The supplemental restraint system verification test procedure should be performed
following service of any supplemental restraint system component.
