Nitro 2WD V6-4.0L (2007)
5. Install the strain gauge alignment tool (Special Tool 9689) on the sensors by inserting the center fork (1) of the tool between the flats on each side
of the sensor body and inside of the cage, then seating the tool support yoke (2) firmly against the outside of the sensor cage.
6. With the alignment tool securing the body of the seat weight sensor (2), remove the nut (4) that secures the sensor stud to the seat track riser (5).
7. Transfer the special tool to each weight sensor, one at a time, and remove the nuts that secure the sensor studs to the seat track risers until all four
nuts have been removed.
8. Carefully separate the seat track risers from the seat weight sensor studs.
9. Remove the two nuts (3) that secure the sensor to the studs on the lower track of the seat adjuster (1).
10. Remove the seat weight sensor from the seat adjuster.
