Nitro 2WD V6-4.0L (2007)
incomplete, or improper side supplemental restraint deployment.
NOTE: The front and side impact sensors are interchangeable.
1. Adjust the driver or passenger side front seat to its most forward position for easiest access to the B-pillar trim.
2. Disconnect and isolate the battery negative cable. Wait two minutes for the system capacitor to discharge before further service.
3. Remove the trim from the inside of the lower right or left B-pillar (1).
4. Remove the nut (2) that secures the side impact sensor (3) to the weld stud on the lower B-pillar.
5. Remove the sensor from the weld stud on the inner B-pillar.
6. Disconnect the body wire harness connector (4) from the sensor connector receptacle.
Side - C-Pillar
SIDE - C-PILLAR
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, occupant classification system, seat belt tensioner, impact sensor, or instrument panel component
diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge
before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the
proper precautions could result in accidental airbag deployment.
WARNING: To avoid serious or fatal injury, never strike or drop the side impact sensor, as it can damage the impact sensor or affect its
calibration. The side impact sensor enables the system to deploy the side curtain supplemental restraints. If an impact sensor is accidentally
dropped during service, the sensor must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental,
incomplete, or improper side supplemental restraint deployment.
NOTE: The front and side impact sensors are interchangeable.
