Nitro 2WD V6-4.0L (2007)
Battery Cable: Service and Repair
Battery Cables - Installation
INSTALLATION
WARNING: Remove metallic jewelry to avoid injury by accidental arcing of battery current.
NOTE: Left hand drive gasoline engine shown, right hand drive and diesel similar.
1. Position the battery cables in the engine compartment.
2. One at a time, install the battery cable retaining pushpins (6), fasteners and routing clips until the cables are installed exactly where they were in
the vehicle.
3. Install the negative battery cable (8) to the mounting stud (2) on the engine block. Install the negative battery cable retaining nut (1).
4. Connect the positive battery cable (7) to the B+ terminal of the starter motor (3). Install the retaining nut (4) and tighten it to 13 Nm (115 in. lbs.).
5. Connect the positive battery cable (2) to the B+ terminal of the generator (5). Install the retaining nut (1) and tighten it to 14 Nm (125 in. lbs.).
