Nitro 2WD V6-4.0L (2007)
19.
Turn off the StarMOBILE scan tool and then restart the scan tool.
NOTE:
The StarMOBILE scan tool must be shut down and restarted to unlock the flash.
20.
From the "System Status" screen press the "Exit" button.
21.
From the "Main Menu" select "Enter Standalone Diagnostic Mode" and press the select button.
22.
Select "ECU View" and press the select button.
23.
Highlight "TIPMCGW" and press the select button.
24.
Select "FLASH ECU" and press the select button.
25.
Compare the highlighted software part number with the software part number displayed at the top of the screen.
>
If the part numbers are the same, the module is up to date and reprogramming is not required. Continue to Step 28.
>
If the software part numbers are different, press the select button to reprogram the module.
26.
When the flash is complete, press the "OK" button.
27.
Clear any Diagnostic Trouble Codes (DTCs) as follows:
NOTE:
Due to the TIPM programming procedure, DTC(s) may be set in other modules (PCM, TCM, ABS, BCM, MIC, WCM, etc.) within the
vehicle, if so equipped. Some DTC's may cause the MIL to illuminate.
a.
From the "Standalone Home" screen highlight "All DTC's" and then press the select button.
b.
Highlight "Clear All Stored" and then press the select button.
c.
Follow the screen prompts on the StarMOBILE screen.
28.
Turn the ignition key to the "OFF" position and remove the StarMOBILE unit, StarMOBILE cable, and battery charger from the vehicle.
