Nitro 2WD V6-4.0L (2007)
Front Steering Knuckle: Service and Repair
Installation
INSTALLATION
CAUTION: The ball joint stud taper must be CLEAN and DRY before installing into the knuckle. Clean the stud taper with mineral spirits to
remove dirt and grease.
1. Install the hub/bearing. (if removed from the knuckle).
2. Install the knuckle to the vehicle.
3. Install the upper ball joint nut. Tighten the nut to 41 Nm (30 ft.lbs.) plus an additional 90° turn.
4. Install the lower ball joint nut. Tighten the nut to 54 Nm (40 ft.lbs.) plus an additional 90° turn.
5. Install the outer tie rod end (1) to the steering knuckle and install the nut (2). Tighten the nut (2) to 41 Nm (30 ft.lbs.) plus an additional 90° turn.
6. Install the axle shaft nut. Tighten the nut to 136 Nm (100 ft.lbs.). (if equipped with four wheel drive).
7. Install the wheel speed sensor.
8. Install the disc brake rotor.
9. Install the caliper adapter.
10. Install the tire and wheel assembly.
11. Perform a wheel alignment
