Nitro 2WD V6-4.0L (2007)
9. Open the TIPM cover and connect the B+ terminal (Figure 18). Tighten the B+ nut to 210 in. lbs. (23 N.m).
10. Remove and discard fuse J20 (pink 30 amp) from the TIPM (Figure 18). Refer to the inside of the TIPM cover to verify fuse location.
11. Close the TIPM cover.
12. Install the "J" nut onto the relay bracket (Figure 19).
13. Connect the new relays and bracket assembly to the overlay wiring
harness connectors.
NOTE:
Both relays are the same and can be plugged into either overlay wiring harness connector.
