Nitro 2WD V6-4.0L (2007)
>
If the last two digits of the part number ends with "AM" or "AN," the TIPM does not require repair. Close the hood and return the vehicle to the
customer. No further action is required.
>
If the last two digits of the part number ends with "AA" through "AL," continue with Section B. Install TIPM Wiper Relay and Overlay Wiring
Harness.
>
If the part number on the TIPM part number tag is missing or not readable, connect a wiTECH, StarSCAN, or StarMOBILE scan tool to the
vehicle and read the TIPM software part number. Use the chart to determine if Wiper Relay and Overlay Wiring Harness installation is required.
NOTE:
The TIPM software part number is different than the module part number.
B. Install TIPM Wiper Relay and Overlay Wiring Harness, Reprogram the TIPM using wiTECH
B Reprogram the TIPM using wiTECH
1. Disconnect the negative battery cable.
2. Open the Totally Integrated Power Module (TIPM) cover and disconnect the large red B+ wire from the TIPM (Figure 2).
