Nitro 4WD V6-4.0L (2007)
5.
Install wheel weight shims to the door module front tabs and pockets as shown making sure to center them in the pockets. (Fig 3)
6.
Cut one wheel weight shim in half to install on center tab. Make sure to install the half wheel weight shim in the center of tab between ribs.
7.
Add one piece of foam tape to upper rear of door trim (Fig.4). Foam tape shall be cut in a 2 in. x 2 in. square piece.**
8.
Install the door handle bezel.
9.
**Install the door trim panel.**
10.
Repeat the process for the other doors as required.
POLICY:
